Saint Remy Fountain

All Weather Cast Conrete

Fountain Instructions:

After preparing
the site, the octagon plinth will go down first with mousehole on the ground
and then the octagon pedestal and octagon basin.
Once these are in place, you will want to install the pump and seal it in
place. You will feed the pump ‘s electrical wire through the 3 pieces and
bring it out of the mousehole on the bottom of the plinth. Using the #7
stopper with the slit and placing the pump wire into the slit, install the
stopper in the center hole of the basin fitting it in a snuggly as possible.
Using the supplied silicone rubber, seal the stopper in place and allow it to
sit until dry before adding water. The square pumpwell will go over the pump
and the provided tubing needs to be attached to the top of the pump and
attached to the pipe coming out of the bottom of the column that will then be
placed upon the pumpwell and the finial put on top.
There are 4 copper spouts and rings that will need to attached to the column.
The fountain is now ready for water and after plugging in the pump, the water
will come out of the spouts after a minute or two.